Conditions for Setting the DTC
WARNING: This page is about a different car, the 2005 Suzuki Swift +, 2005 Pontiac Wave, and 2005 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
- The side air bag sensor wiring of the passenger high is shorted to ground.
- The side air bag sensor wiring of the passenger low is shorted to ground.
DTC 085
| Step | Action | Values | Yes | No |
|---|---|---|---|---|
|
CAUTION:
Refer to SDM Voltage After Ignition Is Turned OFF Caution
in Cautions and Notices.
CAUTION:
Refer to Sensing and Diagnostic Module Handling Caution
in Cautions and Notices.
|
||||
| 1 | Perform the Diagnostic System Check - SIR. Is the Diagnostic System Check - SIR complete? |
- | Go to Step 2 | Go to Diagnostic System Check - SIR |
| 2 |
|
- | Go to Step 4 | Go to Step 3 |
| 3 | Measure the resistance between the SDM and the high, low terminal of the passenger side air bag sensor and the ground. Is the resistance at the specified value? |
10 K Ω | Go to Step 5 | Go to Step 4 |
| 4 | Replace the air bag wiring. Is the repair complete? |
- | Go to Diagnostic System Check - SIR | - |
| 5 |
|
- | Go to Step 6 | Go to Diagnostic System Check - SIR |
| 6 | Replace the passenger side air bag sensor. Is the repair complete? |
- | Go to Diagnostic System Check - SIR | - |