Conditions for Setting the DTC
WARNING: This page is about a different car, the 2005 Suzuki Swift +, 2005 Pontiac Wave, and 2005 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
The resistance of the driver side air bag deployment loop is higher than 2.7 ohms.
DTC 052
| Step | Action | Values | Yes | No |
|---|---|---|---|---|
|
CAUTION:
Refer to SDM Voltage After Ignition Is Turned OFF Caution
in Cautions and Notices.
CAUTION:
Refer to Sensing and Diagnostic Module Handling Caution
in Cautions and Notices.
|
||||
| 1 | Perform the Diagnostic System Check - SIR. Is the Diagnostic System Check - SIR complete? |
- | Go to Step 2 | Go to Diagnostic System Check - SIR |
| 2 | Visually inspect the connector and the wiring of the driver side air bag. Is the connector and wiring OK? |
- | Go to Step 4 | Go to Step 3 |
| 3 | Connect the connector or replace supplemental inflatable restraint (SIR) wiring harness. Is the repair complete? |
- | Go to Diagnostic System Check - SIR | - |
| 4 |
|
0 Ω | Go to Step 6 | Go to Step 5 |
| 5 | Replace the air bag wiring. Is the repair complete? |
- | Go to Diagnostic System Check - SIR | - |
| 6 |
|
- | Go to Diagnostic System Check - SIR | Go to Step 7 |
| 7 | Replace the drive side air bag module. Is the repair complete? |
- | Go to Diagnostic System Check - SIR | - |