LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2004 >> Swift + >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Supplemental Inflatable Restraint System) >> Diagnostic Information and Procedures >> DTC 009 >> Conditions for Setting the DTC
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Conditions for Setting the DTC

WARNING: This page is about a different car, the 2005 Suzuki Swift +, 2005 Pontiac Wave, and 2005 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.

The resistance of the driver belt pretensioner deploy loop is over 3.1 ohms.

DTC 009

Step Action Values Yes No
CAUTION: Refer to SDM Voltage After Ignition Is Turned OFF Caution in Cautions and Notices.
CAUTION: Refer to Sensing and Diagnostic Module Handling Caution in Cautions and Notices.
1 Perform the Diagnostic System Check - SIR.
Is the Diagnostic System Check - SIR complete?		 - Go to Step 2  Go to Diagnostic System Check - SIR 
2
  1. Disconnect the negative battery cable.
  2. Wait 1 minute for the sensing and diagnostic module (SDM) capacitor to discharge.
  3. Examine the wiring and the connector at the driver seat belt pretensioner module.
Is the connector disconnected?		 - Go to Step 3  Go to Step 4 
3
  1. Reconnect the driver seat belt pretensioner module connector.
  2. Reconnect the negative battery cable.
Is the repair complete?		 - Go to Diagnostic System Check - SIR  -
4
  1. Disconnect the electrical connector for the driver seat belt pretensioner module.
  2. Disconnect the electrical connector at the SDM.

    The shorting bar at the disconnected SDM connector will create a complete circuit between the wires from the driver seat belt pretensioner module.

  3. Connect an ohmmeter to the terminals on the SDM side of the wiring harness connector for the driver seat belt pretensioner module.
Does the ohmmeter show the specified value?		 0 Ω Go to Step 5  Go to Step 7 
5
  1. Replace the SDM.
  2. Reconnect the negative battery cable.
  3. Set the scan tool for CODE ERASE.
  4. Perform the Diagnostic System Check - SIR.
Is DTC 009 still shown as a current fault?		 - Go to Step 6  System OK
6
  1. Replace the driver seat belt pretensioner module.
  2. Reconnect the negative battery cable.
Is the repair complete?		 - Go to Diagnostic System Check - SIR  -
7
  1. Replace the supplemental inflatable restraint (SIR) wiring harness.
  2. Reconnect the negative battery cable.
Is the repair complete?		 - Go to Diagnostic System Check - SIR  -
scientia non olet · About LEMON Manuals