Conditions for Setting the DTC

WARNING: This page is about a different car, the 2005 Suzuki Swift +, 2005 Pontiac Wave, and 2005 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.

The resistance of driver air bag deployment loop is lower than 1.4 ohms.
The shorting bar is damaged and then the SDM must be replaced.

DTC 006

Step	Action	Values	Yes	No
CAUTION: Refer to SDM Voltage After Ignition Is Turned OFF Caution in Cautions and Notices. CAUTION: Refer to Sensing and Diagnostic Module Handling Caution in Cautions and Notices.
1	Perform the Diagnostic System Check - SIR. Is the Diagnostic System Check - SIR complete?	-	Go to Step 2	Go to Diagnostic System Check - SIR
2	Disconnect the negative battery cable. Remove the passenger side air bag module. Connect an ohmmeter to the terminals of the wiring harness connector for the passenger air bag module on the sensing and diagnostic module (SDM) side of the connector. Does the ohmmeter show the specified value?	infinity	Go to Step 3	Go to Step 5
3	Replace the SDM. Install the passenger side air bag module. Reconnect the negative battery cable. Set the scan tool to CODE ERASE. Perform the Diagnostic System Check - SIR. Is DTC 006 still shown as a current fault?	-	Go to Step 4	System OK
4	Replace the passenger air bag module. Reconnect the negative battery cable. Is the repair complete?	-	Go to Diagnostic System Check - SIR	-
5	Replace the supplemental inflatable restraint (SIR) wiring harness. Reconnect the negative battery cable. Is the repair complete?	-	Go to Diagnostic System Check - SIR	-