LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2004 >> Swift + >> Repair and Diagnosis >> External Pages >> Different car >> Section 16 (Body Front End) >> Repair Instructions >> Hood Latch Release Cable Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

WARNING: This page is about a different car, the 2005 Suzuki Swift +, 2005 Pontiac Wave, and 2005 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View of Screws and Hood Release Handle From Instrument Panel
    GM1252065Courtesy of GENERAL MOTORS CORP.
  1. Pull out the hood release handle in order to access the screws.
  2. Remove the screws and the hood release handle from the instrument panel.
    3. Fig 2: View of Screws and Splash Shield
    GM1252066Courtesy of GENERAL MOTORS CORP.
  3. Raise and suitably support the vehicle.
    4. NOTE: Refer to Vehicle Lifting and Jacking Notice in Cautions and Notices.
  4. Remove the front wheel. Refer to Tire and Wheel Removal and Installation .
  5. Remove the screws and the splash shield.
    6. Fig 3: View of Hood Release Cable, Screws, and Hood Latch
    GM1252064Courtesy of GENERAL MOTORS CORP.
  6. Open the hood.
  7. Remove the screws and the hood secondary latch.
    8. Fig 4: View of Cable
    GM1252068Courtesy of GENERAL MOTORS CORP.
  8. Remove the cable from the hood release handle.
  9. Remove the cable from inside the vehicle.
scientia non olet · About LEMON Manuals