Installation Procedure

WARNING: This page is about a different car, the 2005 Suzuki Swift +, 2005 Pontiac Wave, and 2005 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View of Fender and Bolts

Courtesy of GENERAL MOTORS CORP.

Install the headlamp.Refer to Headlamp Replacement (Hatchback) or Headlamp Replacement (Notchback)
Install the fender.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Tighten: Tighten the upper fender bolts to 10 N.m (89 lb in).

Install the bolts along the top of the fender.

Fig 2: View of Bolt At Windshield Pillar Base

Courtesy of GENERAL MOTORS CORP.

Install the bolt at the base of the windshield pillar.
Tighten: Tighten the fender-to-windshield pillar bolt to 8 N.m (71 lb in).

Fig 3: View of Bolts At Fender Base

Courtesy of GENERAL MOTORS CORP.

Install the bolts at the base of the fender.
Tighten: Tighten the lower fender bolts to 10 N.m (89 lb in).

Fig 4: View of Screws Underneath Front Bumper Fascia

Courtesy of GENERAL MOTORS CORP.

Secure the fender to the front bumper fascia with the screw.
Tighten: Tighten the front bumper fascia screw to 1.5 N.m (13 lb in).
Secure the fender behind the front bumper fascia with the screws.
Tighten: Tighten the fender screws to 4 N.m (35 lb in).

Fig 5: View of Screws and Splash Shield

Courtesy of GENERAL MOTORS CORP.

Install the splash shield with the screws.
Tighten: Tighten the splash shield screws to 1.5 N.m (13 lb in).
Install the front wheel.
Refer to Tire and Wheel Removal and Installation
Lower the vehicle.