Assembly Procedure

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Compressing Upper Strut Spring

Courtesy of GENERAL MOTORS CORP.

Install the spring to the J 45400 ( KM-329-A ) or equivalent. Ensure the hooks are seated on the spring properly. See Special Tools .
Compress the spring using the J 45400 ( KM-329-A ) or equivalent. See Special Tools .

Fig 2: Strut Mount, Strut Bearing, Spring Upper Seat, Spring Upper Insulator, Hallow Bumper, Coil Spring & Strut Removed

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: Locate the spring to the original position on the spring seat.

Align the match marks and install the spring to the strut.
Install the following components to the strut:
- The bumper stop
- The strut cartridge upper cover
- The spring upper seat
- The strut mount bearing
- The strut mount

NOTE: Refer to Fastener Notice .

Use a wrench in order to hold the threaded piston rod while installing the piston rod nut with the J-44626 ( SA9603E ) or equivalent. See Special Tools .
Tighten: Tighten the piston rod nut to 60 N.m (44 lb ft).
Remove the strut assembly from the J 45400 ( KM-329-A ) or equivalent. See Special Tools .
Install the strut assembly to the vehicle. Refer to Strut Assembly Replacement .