LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2004 >> Swift + >> Repair and Diagnosis >> External Pages >> Different car >> Section 121 (Heating, Ventilation, And Air Conditioning) >> Repair Instructions >> Blower Motor Resistor Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Electrical Connector & Blower Motor Resistor
    GM1251909Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the new resistor into the heater/air distribution case with the screws.

    Tighten:  Tighten the blower resistor retaining screws to 6 N.m (53 lb in).

  2. Connect the electrical connector at the resistor.
  3. Connect the negative battery cable.
  4. Confirm the proper performance of the blower.
scientia non olet · About LEMON Manuals