Installation Procedure

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View of Sunshade

Courtesy of GENERAL MOTORS CORP.

Install the sunshade.

Fig 2: View of Sunroof Housing and Bolts

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install the sunroof housing.
Tighten: Tighten the sunroof housing bolts to 7 N.m (62 lb in).

Fig 3: View of Motor Control Module and Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Install the motor control module.
Manually position the sunroof glass in the fully closed position.

Fig 4: View of Sunroof Module, Motor and Bolts

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: The sunroof motor assembly must be in the fully closed position before installation.

Install the motor.
Tighten: Tighten the sunroof motor screws to 5 N.m (44 lb in).
Install the drain hoses.
Install the headliner. Refer to Headlining Trim Panel Replacement .
Connect the negative battery cable.