Installation Procedure

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Release Arm & Release Shaft

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install the release arm to release shaft and align to the marked position (1).
Tighten: Tighten the release arm bolt and nut to 16 N.m (12 lb ft).
Install the clutch control cable to the release arm and install the clutch control cable adjusting nut.
Adjust the clutch cable. Refer to Clutch Assembly Adjustment