Component Testing
WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the harness connector at the CKP sensor.
- Test for 500-700 ohms between the signal terminal 1 and low reference terminal 2.
- If not within the specified range, replace the CKP sensor.
- Disconnect the fuel pump relay.
- Set the DMM to the AC voltage scale.
- Engine cranking, test for more than 500 mV AC between the signal terminal 1 and low reference terminal 2.
- If less than the specified range, replace the CKP sensor.
IMPORTANT:
If the CKP sensor lead is damaged in any way, replace the CKP sensor.