LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2004 >> Swift + >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - 1.6L (L91) Troubleshooting & Diagnosis) >> Troubleshooting >> Inspection/Maintenance (I/M) Evaporative Emission (EVAP) System Set Procedure >> Test Description
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test Description

The numbers below refer to the step numbers on the diagnostic table.

  1. 1:  Make sure you perform the I/M system check before performing this test. Failure to do so may result in difficulty updating the status to YES.
  2. 3:  This step is to identify a first failure of a type B DTC. A DTC only appears on the I/M System Status display when it becomes a MIL illuminating DTC. This occurs on the second failure of a type B DTC. A first failure of a type B DTC will not allow the I/M System Status to update to YES. Refer to Diagnostic Aids.
  3. 4:  This step is to help identify any unique or unusual criteria required to run the diagnostic test in the event the universal set procedure does not. This information is located in the service information under Conditions for Running the DTC.
  4. 5:  The I/M System Status only reports on whether or not a diagnostic has run, not what the outcome of the test was. If any emission related DTC sets after the tests are complete, the DTC will require diagnosis.
Inspection/Maintenance (I/M) Evaporative Emission (EVAP) System Set Procedure

Step Action Yes No
1  Did you perform the Inspection/Maintenance (I/M) System Check? Go to Step 2  Go to Inspection/Maintenance (I/M) System Check 
2
CAUTION: Refer to Road Test Caution in Cautions and Notices.
  1. Ensure the vehicle is within the Conditions for Running specified in the supporting text.
  2. Turn OFF all of the accessories. For example, the A/C system and the blower fan.
    3. IMPORTANT: Once the engine is started, DO NOT turn OFF the engine for the remainder of the procedure until the test is complete.
    In order for this test to run, the vehicle must operate in the following conditions:
  3. Start the engine.
  4. Acceleration at part throttle to 90 km/h (55 mph) with this speed maintained for 2 minutes.
  5. Deceleration with the throttle closed for more than 10 seconds to 0 km/h (0 mph).
  6. Engine idling for 2 minutes while the following criteria is maintained:
    • Service brake depressed
    • Automatic transmission in drive
Did the EVAP System Status update to YES?		 Go to Step 5  Go to Step 3 
3 With a scan tool, observe the DTC Information.
Does the scan tool indicate any failed DTCs?		 Go to Diagnostic Trouble Code (DTC) List Go to Step 4 
4 
  1. Refer to the Inspection/Maintenance (I/M) System DTC Table  to determine which DTCs are required to run in order to complete this test.
  2. Operate the vehicle within the Conditions for Running the DTC, located in the supporting text for the diagnostic table of the DTC.
  3. Repeat the procedure until the scan tool indicates the diagnostic test has run.
  4. With a scan tool, observe the I/M System Status display.
Did the EVAP System Status update to YES?		 Go to Step 5  Go to Diagnostic Aids
5  With a scan tool, observe the Emission Related DTC portion of the I/M System Status display.
Does the scan tool indicate any Emission Related DTCs set?		 Go to Diagnostic Trouble Code (DTC) List System OK
scientia non olet · About LEMON Manuals