LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2004 >> Swift + >> Repair and Diagnosis >> Electrical >> Instrument Panel System Displays, Gauges And Console >> Diagnostic Information and Procedures >> Door Open Warning Chime Inoperative
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Door Open Warning Chime Inoperative

Door Open Warning Chime Inoperative

Step Action Values Yes No
1 Inspect the chime module connector to make sure it is connected properly.
Is the connector disconnected or partially disconnected?		 - Go to Step 2  Go to Step 3 
2 Connect the electrical connector for the chime module.
Is the repair complete?		 - System OK -
3 Inspect fuse F4.
Is fuse F4 open?		 - Go to Step 4  Go to Step 5 
4
  1. Inspect for a short circuit and repair it, if necessary.
  2. Replace the fuse.
Is the repair complete?		 - System OK -
5
  1. Turn the ignition ON.
  2. Inspect the voltage at fuse F4.
Is the specified voltage available at fuse F4?		 11-14 V Go to Step 7  Go to Step 6 
6 Repair the power supply circuit for fuse F4.
Is the repair complete?		 - System OK -
7
  1. Disconnect the chime module.
  2. Turn the ignition ON.
  3. Inspect the voltage at terminal 8 of the chime module connector.
Does the voltage equal the specified value?		 11-14 V Go to Step 9  Go to Step 8 
8 Repair the open circuit between fuse F4 and the chime module connector.
Is the repair complete?		 - System OK -
9 With the chime module disconnected, use an ohmmeter to check the continuity between terminal 5 of the chime module connector and ground.
Does the ohmmeter indicate the specified value?		 0 Ω Go to Step 11  Go to Step 10 
10 Repair the open circuit between terminal 5 of the chime module connector and ground.
Is the repair complete?		 - System OK -
11
  1. Disconnect the chime module connector.
  2. Make sure the driver side door is open.
  3. Use an ohmmeter to check the continuity between terminal 4 of the chime module and ground.
Does the ohmmeter indicate the specified value?		 0 Ω Go to Step 12  Go to Step 13 
12 Replace the chime module.
Is the repair complete?		 - System OK -
13
  1. Disconnect the front door contact switch.
  2. Use an ohmmeter to check the continuity between the door contact switch and terminal 4 of the chime module.
Does the ohmmeter indicate the specified value?		 0 Ω Go to Step 15  Go to Step 14 
14 Repair the open circuit between the door contact switch and terminal 4 of the chime module.
Is the repair complete?		 - System OK -
15 Replace the door contact switch.
Is the repair complete?		 - System OK -
scientia non olet · About LEMON Manuals