LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2004 >> Swift + >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brake System >> Repair Instructions >> Proportioning Valve Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: View Of Master Cylinder Body Valves
    GM1245637Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Brake Fluid Caution in Cautions and Notices.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
    IMPORTANT: Since these valves are adjusted in pairs to the correct control range, they must be replaced in pairs.
  1. Install the proportioning valves to the cylinder body.

    Tighten:  Tighten the proportioning valves to 35-44 N.m (26-33 lb ft).

  2. Connect the brake lines to the valves.

    Tighten:  Tighten the brake lines to 16 N.m (12 lb ft).

    3. NOTE: Refer to Vehicle Lifting and Jacking Notice in Cautions and Notices.
  3. Raise and suitably support the vehicle.
  4. Bleed the braking system. Refer toHydraulic Brake System Bleeding (Manual)  or Hydraulic Brake System Bleeding (Pressure) .
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals