LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2004 >> Swift + >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bumper System >> Repair Instructions >> Fascia Replacement - Front Bumper >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: View of Front Bumper Fascia
    GM1248503Courtesy of GENERAL MOTORS CORP.
  1. Install the bumper fascia.
  2. Install the screws on the top of the fascia.
    3. Fig 2: View of Screws Underneath Fascia
    GM1248502Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the screws underneath the fascia.
  4. Install the nuts behind the fascia.

    Tighten:  Tighten the front bumper impact beam nuts to 27 N.m (20 lb ft).

  5. Install the screws in the wheel wells.

    Tighten:  Tighten the front wheel well screws to 1.5 N.m (13 lb in).

  6. Install the headlamps, the turn signal lamp, the side turn signal lamps, and the front fog lamps.

    Refer to Headlamp Replacement (Hatchback)Headlamp Replacement (Notchback) , Turn Signal Lamp Replacement (Hatchback)Turn Signal Lamp Replacement (Notchback) and Fog Lamp Replacement - Front in Lighting Systems.

    7. Fig 3: View of Screws, Bolts, Nuts, and Front Wheel Well Splash Shields
    GM1248501Courtesy of GENERAL MOTORS CORP.
  7. Install the front wheel well splash shields with the screws, the bolts, and the nuts.
  8. Install the front wheels.

    Refer to Tire and Wheel Removal and Installation in Tires and Wheels.

    Tighten: 

    • Tighten the splash shield screws to 1.5 N.m (13 lb in).
    • Tighten the splash shield bolts to 1.5 N.m (13 lb in)
    • Tighten the splash shield nuts to 1.5 N.m (13 lb in).

  9. Connect the negative battery cable.
scientia non olet · About LEMON Manuals