Lower Valve Body Components: Assembly
Assemble each component by reversing disassembly procedure and noting the following points.
- Coil outer diameter and free length of each valve spring should be as listed below. Be sure to use each one of correct size.
Courtesy of SUZUKI OF AMERICA CORP.
- Install primary regulator valve sleeve so that its tip is positioned as it was before disassembly.
- Use new TCC (lock-up) control valve gasket, solenoid gasket and lower valve body plate gasket.
- Tighten shift solenoid valve bolt to specified torque.
Tightening torque
- Shift solenoid valve bolt: 10 N.m (1.0 kg-m, 7.5 lb-ft)
- Tighten TCC (lock-up) solenoid valve bolt to specified torque.
Tightening torque
- TCC solenoid valve bolt: 5.5 N.m (0.55 kg-m, 4.0 lb-ft)
- Tighten pressure relief valve bolt to specified torque.
Tightening torque
- Pressure relief valve bolt: 5.5 N.m (0.55 kg-m, 4.0 lb-ft)
- Tighten lower valve body plate (1), TCC (lock-up) control valve plate (2) flange bolt to specified torque.
Tightening torque
- Lower valve body and TCC control valve Plate bolts: 5.5 N.m (0.55 kg-m, 4.0 lb-ft)