LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2004 >> Forenza S, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Servicing - A/T) >> Removal & Installation >> Control Valve Body Assembly >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Control Valve Body Assembly: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the negative battery cable.
  2. Disconnect the transaxle wiring harness and the park/neutral position switch electrical connector. See Fig 1 .
  3. Raise and suitably support the vehicle.
  4. Remove the engine under cover.
  5. Remove the transaxle fluid drain plug using the plug removal/installer and drain the transaxle fluid. See Figure .
  6. Remove the oil pan, oil pan gasket. See OIL PAN  .
  7. Remove the valve body mounting bolts.
  8. Remove the automatic transmission input speed sensor mounting bolt. See Fig 2 .
  9. Tilt the valve body.
  10. Remove the automatic transmission output speed sensor mounting bolt under the valve body assembly. See Fig 3 .
  11. Remove the control valve body. See Fig 4 .
Fig 1: Disconnecting Transaxle Wiring Harness
G00311844Courtesy of SUZUKI OF AMERICA CORP.
Fig 2: Removing Input Speed Sensor Mounting Bolt
G00311848Courtesy of SUZUKI OF AMERICA CORP.
Fig 3: Removing Output Speed Sensor Mounting Bolt
G00311852Courtesy of SUZUKI OF AMERICA CORP.
Fig 4: Removing Control Valve Body
G00311856Courtesy of SUZUKI OF AMERICA CORP.
scientia non olet · About LEMON Manuals