Fluid Level Set After Service
WARNING: This page is about a different variant/trim than selected.
- Add transaxle fluid through the fill cap hole prior to adjusting the fluid level. The amount of fluid to add should be based on the type of service done.
- Oil pan removed 4.2 Qts. (4 L).
- Torque converter removed 2.1 Qts. (2 L).
- Complete overhaul 8.0 - 7.6 Qts. (7.2 - 7.6 L).
- Drain plug removed 4.2 Qts. (4 L).
- Check the transaxle fluid level. See DRAINING & REFILLING .
- Add additional fluid through the fill cap hole in .5 Qts. (.5 L) increments until the fluid comes out through the plug hole.
- Allow the fluid to finish draining out through the plug hole, then install the fluid level plug.
- When the checking fluid level procedure is completed, wipe any fluid from the transaxle case with a rag or shop towel. Also, check that the fluid fill cap and the vent tube are properly installed.