Tools Required

WARNING: This page is about a different variant/trim than selected.

DW260-050 P/N Switch Installer

Install the park/neutral start switch.
Tighten

Tighten the bolts to 10 N.m (89 lb-in).
Adjust the park/neutral switch using the P/N switch installer DW260-050.
NOTE: When install the park/neutral switch, using the special service tools and the shift lever must be positioned "Neutral".

Fig 1: Adjusting The Park/Neutral Switch
Courtesy of SUZUKI OF AMERICA CORP.
Install the shift lever and the shift lever nut.

Fig 2: Installing The Shift Lever
Courtesy of SUZUKI OF AMERICA CORP.

Tighten

Tighten the shift lever nut to 10 N.m (89 lb-in).
Connect the shift control cable and the retaining clip.

Fig 3: Connecting The Shift Control Cable And The Retaining Clip
Courtesy of SUZUKI OF AMERICA CORP.
Connect the park/neutral position switch electrical connector.
Connect the negative battery cable.