DBC 7 ABS Assembly Removal and Installation: Removal

WARNING: This page is about a different car, the 2004 Suzuki Verona. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the negative battery cable.
Removed the cooling surge tank. Refer to SURGE TANK REMOVAL .
Disconnect the ABS wiring harness connector from its socket on the EBCM.
Cover the connector and the socket with shop cloths to protect them from brake fluid.

Fig 1: Covering Connector & Socket With Shop Cloths

Courtesy of SUZUKI OF AMERICA CORP.

Remove the brake pipes fitting nuts from the hydraulic unit.
NOTE: Take care not to allow air into the hydraulic unit or into the brake pipes from the master cylinder. If air gets into the hydraulic unit, it will require a bleeding procedure using a scan tool programmed for the DBC 7 ABS system. As long as no air enters the hydraulic unit, a simple bleeding procedure is all the system will require.
Remove the mounting bracket bolts on the hydraulic unit.
Remove the DBC 7 ABS assembly.