Oil Pump Removal and Installation: Installation
WARNING: This page is about a different car, the 2004 Suzuki Aerio, 2003 Suzuki Aerio, and 2002 Suzuki Aerio. However, it is still accessible from the selected car via links, so may be relevant.
- Install oil pump (2) and baffle plate to lower crank case (1) and tighten bolts to specified torque.NOTE: When installing oil pump, be careful not to allow pins to fall off.
Tightening torque
Oil pump mounting bolt (M8 bolt) (a): 25 N.m (2.5 kg-m, 18.0 lb-ft)
Baffle plate bolt (M6 bolt): 11 N.m (1.1 kg-m, 8.0 lb-ft)
- Install oil pump sprocket cover (1) and tighten bolts to specified torque.
Tightening torque
Oil pump sprocket cover bolt (a): 11 N.m (1.1 kg-m, 8.0 lb-ft)
- Install oil pan and oil pump strainer. Refer to Oil Pan and Oil Pump Strainer Removal and Installation .
- Refill engine with engine oil.
- Connect negative cable at battery.
- After completing installation, check oil pressure by running engine. Refer to Oil Pressure Check .