Input Shaft Speed Sensor Removal and Installation: Installation

WARNING: This page is about a different car, the 2004 Suzuki Aerio, 2003 Suzuki Aerio, and 2002 Suzuki Aerio. However, it is still accessible from the selected car via links, so may be relevant.

Apply A/T fluid to new input shaft speed sensor O-ring.
Install input shaft speed sensor (1) to A/T case and tighten bolt to specified torque.
Tightening torque

Input shaft speed sensor bolt (a): 5.5 N.m (0.55 kg-m, 4.0 lb-ft)
Connect input shaft speed sensor connector (2) to input shaft speed sensor (1).

Fig 1: Connecting Input Shaft Speed Sensor Connector
Courtesy of SUZUKI OF AMERICA CORP.
Connect negative cable to battery.