Front Strut Assembly Removal and Installation: Installation
WARNING: This page is about a different car, the 2004 Suzuki Aerio, 2003 Suzuki Aerio, and 2002 Suzuki Aerio. However, it is still accessible from the selected car via links, so may be relevant.
Install strut assembly by reversing removal procedure, noting the following instructions.
- Insert bolts in such direction as shown in figure.
- Tighten all fasteners to specified torque.
Tightening torque
Strut bracket nut (a): 105 N.m (10.5 kg-m, 76.0 Ft.Lbs)
Strut support nut (b): 28 N.m (2.8 kg-m, 20.5 Ft.Lbs)
Brake hose mounting bolt (c): 25 N.m (2.5 kg-m, 18.0 Ft.Lbs)
Stabilizer joint nut (d): 50 N.m (5.0 kg-m, 36.5 Ft.Lbs)
NOTE:
- Don't twist brake hose and ABS wheel speed sensor harness (if equipped) when installing it.
- Install ABS wheel speed sensor harness (if equipped) to strut bracket as shown in figure.
- Tighten wheel nut to specified torque.
Tightening torque
Wheel nut: 85 N.m (8.5 kg-m, 61.5 Ft.Lbs)
- After installation, confirm front wheel alignment.