Knuckle/Hub Assembly: Removal

WARNING: This page is about a different car, the 2004 Suzuki Verona. However, it is still accessible from the selected car via links, so may be relevant.

Remove the wheel.
Remove the caulking nut and washer. See Fig 1.
Remove the outer tie rod. See Fig 2.
Disconnect the control arm ball joint. See Figure.
Remove the brake caliper.
Remove the detent screw from the brake disc. See Fig 3. Remove the disc.
Remove the splash shield. See Fig 4.
Remove the front strut bolts. See Figure.
Remove the knuckle/hub assembly. See Fig 5.
Remove the hub bolts from the knuckle and separate the hub from the knuckle. See Fig 6.

Fig 1: Identifying Caulking Nut & Washer

Courtesy of SUZUKI OF AMERICA CORP.

Fig 2: Removing/Installing Tie-Rod End

Courtesy of SUZUKI OF AMERICA CORP.

Fig 3: Removing Disc Detent Screw

Courtesy of SUZUKI OF AMERICA CORP.

Fig 4: Removing Splash Shield

Courtesy of SUZUKI OF AMERICA CORP.

Fig 5: Removing Knuckle/Hub Assembly

Courtesy of SUZUKI OF AMERICA CORP.

Fig 6: Removing Hub Assembly From Knuckle

Courtesy of SUZUKI OF AMERICA CORP.