LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2004 >> Forenza EX >> Repair and Diagnosis >> External Pages >> Different car >> Section 22 (Front Suspension) >> Removal & Installation >> Control Arm >> Reassembly
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Control Arm: Reassembly

WARNING: This page is about a different car, the 2004 Suzuki Verona. However, it is still accessible from the selected car via links, so may be relevant.
  1. Coat the control arm rear shaft with a multipurpose lubricant.
  2. Press the control arm front bushing into the control arm using a press, the Removal/Installer (KM-508-A) and the Removal Plate (KM-307-B). See Figure. Center the bushing.
  3. Coat the outside of the control arm front bushing and the inside of the control arm with a multipurpose lubricant.
  4. Press the control arm rear bushing into the control arm using a press, the Remover/Installer (KM-508-A), and the Removal Plate (KM-307-B). See Fig 1. Center the bushing.
  5. Install the control arm. See INSTALLATION .
Fig 1: Installing Control Arm Rear Bushing
G00356832Courtesy of SUZUKI OF AMERICA CORP.
scientia non olet · About LEMON Manuals