Selector Cable
- Remove adjuster (cable end) from selector lever pin of selector lever assembly.
- Shift manual shift lever "1" to Neutral range (transmission range sensor "N" range) aligning arrow "2" of lever "1" with Neutral reference line "3". See Fig 1
.
- Release lock plate "1" which restrict moving of cable end holder "2". See Fig 2
.
- Push cable end holder "1" out from eye end "2" using an appropriate tool "3" to disengage cable. See Fig 3
.
- Shift selector lever to Neutral position.
- Apply grease to selector lever pin and install adjuster (cable end) to it.
- With both selector lever and transmission range sensor kept each Neutral position, drive cable end holder "1" in until it locks cable.
- Slide lock plate "2" to secure cable end holder in position. See Fig 4
.
- After select cable was installed , check for the following.
- Push vehicle with selector lever shifted to Park range. Vehicle should not move.
- Vehicle can not be driven in Neutral range.
- Vehicle can be driven in Drive, "2", and Low ranges.
- Vehicle can be backed in Reverse range.
Courtesy of SUZUKI OF AMERICA CORP.
Courtesy of SUZUKI OF AMERICA CORP.
Courtesy of SUZUKI OF AMERICA CORP.
Courtesy of SUZUKI OF AMERICA CORP.