Gear Shift and Select Shaft Disassembly and Assembly
WARNING: This page is about a different variant/trim than selected.
- Push spring pins out using 2.8 - 3.0 mm (0.11 - 0.12 in.) commercially available spring pin remover and specified spring pin removers as shown bellow.
Special tool
(A): 09922-85811 (4.5 mm)
(B): 09925-78210 (6.0 mm)
- Inspect component parts for wear, distortion or damage. If any detect is found, replace detective part with new one.NOTE:
- When driving in spring pins, prevent shaft from being bent by supporting it with wood block.
- Assemble 5th & reverse gear shift cam with its pit and spring pin aligned.
- Make sure to select an appropriate spring by identifying the painted colors to keep gear shifting performance as designed.
- Low speed select spring - No paint
- Reverse select spring - Pink