DTC Confirmation Procedure
WARNING:
- When performing a road test, select a place where there is no traffic or possibility of a traffic accident and very careful during testing to avoid occurrence of an accident.
- Road test should be carried out with 2 persons, a driver and tester, on a level road.
NOTE:
- Check to make sure that the following conditions are satisfied when using this "DTC Confirmation Procedure".
- Intake air temperature: -14°C (6.8°F) or higher
- Altitude (barometric pressure): 2500 m, 8202 ft or less (560 mmHg, 75 kPa or more)
- With ignition switch turned OFF, connect scan tool.
- Turn ON ignition switch and clear DTC using scan tool.
- Start engine and warm up to normal operating temperature. (ECT approx. 90 - 95°C, 194 - 203°F)
- Increase vehicle speed till engine speed is reached 2000 - 4500 r/min and keep it for 10 sec or more.
- Stop vehicle and check DTC and pending DTC.