Center Shaft: Reassembly

NOTE: Refer to the exploded view as needed during this procedure. See Figure .

Install center shaft by reversing removal procedure noting the following.

When installing circlips (1), make sure that they fit in circlip grooves in center shaft support bracket (2) securely. See Fig 1 .
When installing oil seals, use care so that they are in proper direction.
Fill the space between oil seals and center shaft support bearing (3) with grease. See Fig 2 .
Press-fit center shaft (1) from LH oil seal side. See Fig 3 .

Fig 1: Fitting Circlip Grooves In Center Shaft

Courtesy of SUZUKI OF AMERICA CORP.

Fig 2: Filling Space Between Oil Seals & Center Shaft

Courtesy of SUZUKI OF AMERICA CORP.

Fig 3: Press-Fit Center Shaft

Courtesy of SUZUKI OF AMERICA CORP.