DRL System Circuit Inspection

Disconnect negative (-) cable at battery.
Remove glove box (1) from instrument panel (2) as shown.
Disconnect DRL connector (3).

Fig 1: Locating Components
Courtesy of SUZUKI OF AMERICA CORP.
Connect negative (-) cable at battery.
Check that voltage and resistance between the following terminals and body ground are specifications under each conditions.
If check result is OK, replace DRL controller. If check result is not as specified, repair circuit.

Fig 2: Identifying Terminals
Courtesy of SUZUKI OF AMERICA CORP.

Fig 3: Voltage/Resistance Test Chart
Courtesy of SUZUKI OF AMERICA CORP.