DTC Confirmation Procedure
NOTE:
- Check to make sure that the following conditions are satisfied when using this "DTC Confirmation Procedure".
- Intake air temp.: Between -14°C and 70°C (6.8°F and 158°F)
- Altitude (barometric pressure): 2500 m, 8202 ft or less (560 mmHg, 75 kPa or more)
- Transmission gear shift lever is shifted in "Neutral" for M/T (in "P" position for A/T)
- Electric load (lighting, heater blower, rear defogger, etc.) and A/C are turned OFF.
- With ignition switch turned OFF, connect scan tool.
- Turn ON ignition switch and clear DTC using scan tool.
- Start engine and warm up to normal operating temperature (80°C - 110°C, 176° - 230°F).
- Run engine at idle speed (600 - 1000 r/min.) for 5 min. or more.
- Check DTC and pending DTC.