LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2003 >> XL-7 Base, RWD >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Air Conditioning Systems >> Diagnostic Information and Procedures >> DTC Clearance >> Using SUZUKI Scan Tool
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Using SUZUKI Scan Tool

  1. Turn ignition switch to OFF position.
  2. Connect SUZUKI scan tool to data link connector (DLC) (1).

    Special tool 

    (A):  SUZUKI scan tool

    Fig 1: Connecting Scan Tool To Data Link Connector
    G01326857Courtesy of SUZUKI OF AMERICA CORP.
  3. Light over sunload sensor vertically with an incandescent lamp of approx. 100 W apart from about 100 mm (3.94 in.) position.
  4. Turn ignition switch to ON position.
  5. Erase DTC according to instructions displayed on SUZUKI scan tool. Refer to SUZUKI scan tool operator's manual for further details.
  6. After completing the clearance, turn ignition switch to OFF position and disconnect SUZUKI scan tool from DLC.
  7. Perform DTC CHECK  and confirm if normal DTC (NO CODES) is displayed.
scientia non olet · About LEMON Manuals