DTC Confirmation Procedure
WARNING: This page is about a different variant/trim than selected.
WARNING:
- When performing a road test, select a place where there is no traffic or possibility of a traffic accident and be very careful during testing to avoid occurrence of an accident.
- Road test should be carried out with 2 persons, a driver and a tester, on a level road.
- Connect scan tool to DLC with ignition switch OFF.
- Clear DTC, pending DTC and freeze frame data by using scan tool.
- Shift select lever to "D" range and start vehicle.
- Keep vehicle speed at lower than 10 km/h (7 mile/h) for 10 sec. or more.
- Stop vehicle.
- Check pending DTC and DTC.