Oil Cooler Hoses: Installation
WARNING: This page is about a different variant/trim than selected.
When replacing components, be sure to note the following: See Figure
- Replace clamps at the same time
- Insert hose as far as its limit mark
- Clamp hose securely
- Use new union gasket "2" and connect oil cooler pipes "1" to oil outlet unions.
- Connect hoses to pipes and clamp them securely.
- Tighten union bolts to specified torque with oil outlet union locked. See TORQUE SPECIFICATIONS .
- Tighten pipe bolt "3" securely.
- Check A/T fluid level. See CHECKING FLUID LEVEL .
- Check for fluid leakage after warming up A/T.