Quarter Window Removal and Installation for H25 Engine Model

Refer to HEAD LINING REMOVAL AND INSTALLATION , WINDSHIELD REMOVAL AND INSTALLATION procedures and cautions are basically the same. However, note the following.

NOTE:

Before applying primer (5) to glass edge, install molding (3) according to installing position shown in the figure.
Observe the following precautions when applying adhesive (4) along glass edge.
- Adhesive should be applied evenly especially in height.
- Be careful not to damage primer.
- Press glass (2) against body quickly after adhesive is applied.
  Adhesive amount specifications (quarter window)
  1. Height "b": 12 mm (0.47 in.)
  2. Width "c": 8 mm (0.31 in.)
  3. Width "d": 16 mm (0.63 in.)
  4. Clearance "e": 1 mm (0.04 in.)
Fig 1: Removing/Installing Quarter Window (H25 Engine Model)
Courtesy of SUZUKI OF AMERICA CORP.