Transfer 4WD Switch Removal and Installation

Remove console box and lift transmission control lever boots No. 2 and No. 3.
Refer toTRANSMISSION SHIFT CONTROL LEVER REMOVAL AND INSTALLATION .
Remove transfer control lever boot No. 2 (3), unclamp wiring on transfer case to free it and pull off coupler (1).
Replace 4WD switch (2) and connect as it was.
Tightening torque
1. 4WD switch (a): 20 N.m (2.0 kg-m, 14.5 lb-ft)
Fig 1: Replacing 4WD Switch
Courtesy of SUZUKI OF AMERICA CORP.
Turn ON ignition switch, shift transfer shift control lever to 4WD position and check that indicator lights. Turn OFF switch after checking.
NOTE:
- When removing and reinstalling switch, use care not to let dust enter transfer box inside.
- Make sure to reset clamp for wiring which is located where invisible directly.
- It is recommended to work on transfer shift control lever boot No. 1 from underside of vehicle on lift.