Rear-End Door / Rear-End Gate Lock Assembly Removal And Installation: Installation

Reverse removal procedure to install rear-end door lock assembly noting the following points.

• Rear-end door / rear-end gate latch striker so that its center aligns with the center of groove in rear-end door / rear-end gate latch base. To adjust rear-end door / rear-end gate latch and striker with each other, insert proper number of shims (1) below the bottom of striker, as shown.
  Fig 1: Adjusting Striker

  Courtesy of SUZUKI OF AMERICA CORP.
• Rear-end door / rear-end gate rubber cushion.

  Move rubber cushion (1) installed at the left side of rear-end door / rear-end gate to align it with its guide.

Fig 2: Aligning Rubber Cushion

Courtesy of SUZUKI OF AMERICA CORP.