Heater Blower Unit

Removal
1. Disconnect negative (-) cable at battery.
2. Disable air bag system, if equipped. Refer to "Disabling Air Bag System:".
3. Open glove box, then remove screw.
4. Remove glove box.




5. Remove passenger lower member (1).




6. Remove ECM (1) with bracket (2) from blower motor unit (4).




7. Disconnect blower motor, blower motor relay (2) and resistor lead wires at couplers (3).
8. Remove cooling unit (If equipped). Refer to "Heater Unit Removal and Installation:".
9. Disconnect fresh air control cable from blower motor case.




10. Remove fastening nuts (1), remove blower motor unit.

Installation
1. Reverse removal procedure for installation.
2. Connect fresh air control cable referring to "Heater Control Cables Removal and Installation:".
3. Enable air bag system, if equipped. Refer to "Enabling Air Bag System:".