Input Shaft

Disassembly





1) Take out oil sea[ (1) from input shaft oil seal retainer (2) and install new oil seal (1) with special tool (A) and hammer up to case surface. Unless oil seal (1) is leaky or its lip is excessively hardened, replacement is unnecessary.





2) Remove circlip of input shaft (1) and pull out bearing (2) with bearing puller (3) and press as necessary.

NOTE: Sealed bearing must not be washed. Replace it with now one when required.

Reassembly





1) When installing bearing (1), bring it so that its groove for circlip is in the front and press-fit with special tool (B) and press.





2) After fitting circlip (1), air-blow lubrication oil hole (2).