Rear

Removal
1. Raise and suitably support vehicle.
2. Remove tire and wheel.
3. Clean dirt and foreign material from both hose end or pipe end fittings.
4. Remove brake hose or pipe.

Installation
Remove removal procedure for brake hose or pipe installation procedure.
^ Be sre to obtain more than 3 mm (0.118 inch) clearance between axle housing and brake pipe.
^ Install clamps properly.
^ When installing hose, make sure that it has no twist or kink.
^ Fill and maintain brake fluid level in reservoir. Bleed brake system
^ Perform brake test and check each installed part for fluid leakage.