DTC Confirmation Procedure
WARNING: This page is about a different variant/trim than selected.
WARNING:
- When performing a road test, select a place where there is no traffic or possibility of a traffic accident and be very careful during to avoid occurrence of an accident.
- Road test should be carried out with 2 persons, a driver and a tester, on a level road.
- Connect scan tool to DLC with ignition switch OFF.
- Clear DTC, pending DTC and freeze frame data in PCM memory by using scan tool.
- Start engine and shift transfer lever to "2H" or "4H" range.
- Drive vehicle at, 40 km/h (25mph) or more for longer than 10 sec. (or higher than 3500 rpm engine speed with "D" range for longer than 10 sec.)
- Stop vehicle and check pending DTC and DTC by using scan tool.