DTC Confirmation Procedure
WARNING:
- When performing a road test, select a place where there is not traffic or possibility of a traffic accident and be very careful during resting to avoid occurrence of an accident.
- Road test should be carried out with 2 persons, a driver and a tester, on a level road.
- Connect scan tool to DLC with ignition switch OFF.
- Clear DTC, pending DTC and freeze frame data in PCM memory by using scan tool and start engine.
- Shift A/T selector lever to each of L, 2, D, N, R and P ranges for 30 seconds each.
- Increase vehicle speed to about 70 km/h (45 mph) in D range.
- Keep driving above vehicle speed for 30 seconds.
- Release accelerator pedal, decrease vehicle speed and stop vehicle.
- Check pending DTC and DTC.