LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2003 >> Aerio S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 52 (Automatic A/C Systems) >> Diagnostic Information and Procedures >> Using SUZUKI Scan tool
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Using SUZUKI Scan tool

WARNING: This page is about a different car, the 2004 Suzuki Aerio. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch to OFF position.
  2. Connect SUZUKI scan tool to data link connector (DLC) (1) located on underside of instrument panel at driver's seat side.
    Fig 1: Connecting SUZUKI Scan Tool To Data Link Connector
    G00764141Courtesy of SUZUKI OF AMERICA CORP.
  3. Light over sunload sensor vertically with an incandescent lamp approximately 60 W apart from about 100 mm (3.94 in.).
    NOTE: If sunload sensor is not lighted over with an incandescent lamp, DTC B1504 is detected even though there is not any malfunction.
  4. Turn ignition switch to ON position.
  5. Erase DTC according to instructions displayed on SUZUKI scan tool.
    NOTE: To know how to use SUZUKI scan tool, refer to operator's manual for SUZUKI scan tool.
  6. After completing the clearance, turn ignition switch to OFF position and disconnect SUZUKI scan tool from DLC.
  7. Perform On-Board Diagnostic System Description  , and confirm if normal DTC (NO CODES) is displayed on SUZUKI scan tool.
scientia non olet · About LEMON Manuals