LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2003 >> Aerio S, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Self-Diagnostics >> Diagnostic Tests >> DTC P0300, DTC P0301, DTC P0302, DTC P0303 Or DTC P0304 >> Diagnosis & Repair Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnosis & Repair Procedure

NOTE: For better performance and results of this diagnostic procedure, usage of appropriate wiring diagram is recommended. See ENGINE PERFORMANCE in SYSTEM WIRING DIAGRAMS article in ELECTRICAL.
NOTE: Perform all voltage and resistance tests using a Digital Volt-Ohmmeter (DVOM) with a minimum 10-megohm input impedance, unless stated otherwise in test procedure. Use an ohmmeter to isolate wiring harness shorts or opens.
  1. If engine system check has been performed, go to next step. If engine system check has not been performed, perform TEST D: ENGINE SYSTEM CHECK  under SYSTEM TESTS, then go to next step.
  2. Turn ignition switch to ON position. Ensure fuel gauge indicates fuel in fuel tank. If fuel gauge indicates fuel, go to next step. If fuel gauge indicates empty, add fuel to vehicle and repeat DTC CONFIRMATION TEST .
  3. Perform ignition system check (spark plugs and ignition spark) referring to IGNITION CHECKS in BASIC DIAGNOSTIC PROCEDURES article. If ignition system is okay, go to next step. If ignition system is faulty, repair as necessary and repeat DTC CONFIRMATION TEST .
  4. Perform suspect fuel injector circuit check. See B-2: FUEL INJECTOR CIRCUIT INSPECTION under CIRCUIT TESTS in BASIC DIAGNOSTIC PROCEDURES article. If fuel injector circuit is okay, go to next step. If fuel injector circuit is faulty, repair as necessary and repeat DTC CONFIRMATION TEST .
  5. Check system fuel pressure. See FUEL PRESSURE under FUEL SYSTEM in BASIC DIAGNOSTIC PROCEDURES article. If fuel pressure is as specified, go to next step. If fuel pressure is not as specified, repair as necessary and repeat DTC CONFIRMATION TEST .
  6. Perform suspect fuel injector inspection. See FUEL INJECTORS under FUEL SYSTEM in SYSTEM & COMPONENT TESTING article. If fuel injectors are okay, go to next step. If fuel injectors are faulty, repair as necessary and repeat DTC CONFIRMATION TEST .
  7. Perform ignition timing inspection. See IGNITION TIMING in ON-VEHICLE ADJUSTMENTS article. If ignition timing is as specified, go to next step. If ignition timing is not as specified, adjust timing as necessary and repeat DTC CONFIRMATION TEST .
  8. Perform EGR system inspection. See EXHAUST GAS RECIRCULATION under EMISSION SYSTEMS & SUB-SYSTEMS in SYSTEM & COMPONENT TESTING article. If EGR system is operating properly, go to next step. If EGR system is faulty, repair as necessary and repeat DTC CONFIRMATION TEST .
  9. Perform fuel level sensor inspection referring to step  4 in DTC P0461: FUEL LEVEL SENSOR CIRCUIT - PERFORMANCE. If diagnostic results are okay, go to next step. If diagnostic results are faulty, repair as necessary and repeat DTC CONFIRMATION TEST .
  10. Perform engine mechanical system check. See MECHANICAL INSPECTION under PRELIMINARY INSPECTION in BASIC DIAGNOSTIC PROCEDURES article. If engine mechanical conditions are faulty, repair as necessary and repeat DTC CONFIRMATION TEST . If engine mechanical conditions are okay, problem is intermittent, check ECM, ignition system and fuel injectors for intermittent open or short circuit. See INTERMITTENTS in TROUBLE SHOOTING - NO-CODES article. After repair, repeat DTC CONFIRMATION TEST .
scientia non olet · About LEMON Manuals