B1032

Wiring Diagram:

CAUTION:
- Be sure to perform "Air Bag Diagnostic System Check" before starting diagnosis according to flow.
- When measurement of resistance or voltage is required in this table, use a specified digital multimeter (Refer to "Special Tool".) along with a correct terminal adapter from special tool (Connector test adapter kit).
- When a check for proper connection is required, refer to "Inspection of Intermittents and Poor Connections".
- If there is open circuit in the air bag wire harness, connector or terminal is found damaged, replace the wire harness, connector and terminal as an assembly.

DTC Will Set When
The power source voltage is below an approx. 8 V for specified time.

Test Description
STEP 1: Check if voltage on battery is within normal range.
STEP 2: Check if voltage applied to SDM is within normal range.
STEP 3: Check if voltage applied to "G14" connector is within normal range.
STEP 4: Check if DTC B1032 still exists.

Step 1:

Step 2 - 4:

Troubleshooting

NOTE:
Upon completion of inspection and repair work, perform the following items.
- Reconnect all air bag system components, ensure all components are properly mounted.
- Clear diagnostic trouble codes (Refer to "DTC Clearance"), if any.
- Repeat "Air Bag Diagnostic System Check" to confirm that the trouble has been corrected.