Shift Control Levers Removal and Installation: Installation

WARNING: This page is about a different car, the 2004 Suzuki Vitara. However, it is still accessible from the selected car via links, so may be relevant.

If control lever locating bolts (1) are replaced or retightened, torque them as specified. Replacing of control lever locating bolts (1) requires thread lock cement.
"B": Thread lock cement 99000-32020

Tightening torque

Transmission control lever locating bolt (a): 23 N.m (2.3 kg-m, 17.0 lb-ft)

Transfer control lever locating bolt (b): 17 N.m (1.7 kg-m, 12.5 lb-ft)
Apply grease to pivot portions and seat, then install shift control lever.
"A": Grease 99000-25010

Fig 1: Applying Grease To Pivot Portions And Seat
Courtesy of SUZUKI OF AMERICA CORP.
Install transmission boot No. 1 (1) from inside of cabin and clamp it with a new clamp (2) securely.

Fig 2: Installing Transmission Boot No. 1
Courtesy of SUZUKI OF AMERICA CORP.
Install transfer boot No. 1 (1) securely on lift and clamp it by using a new clamp (2).

Fig 3: Installing Transfer Boot No. 1
Courtesy of SUZUKI OF AMERICA CORP.
Tighten transmission boot No. 2 with boot cover (2) and console box bracket (1).
Tightening torque

Control lever boot cover bolt (a): 6 N.m (0.6 kg-m, 4.5 lb-ft)
Install console box.

NOTE: Be sure that flare end of transmission boot No. 3 (3) is engaged with console box.

Fig 4: Installing Console Box

Courtesy of SUZUKI OF AMERICA CORP.