Rear Wheel Speed Sensor Removal and Installation: Removal

WARNING: This page is about a different car, the 2004 Suzuki Vitara. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect negative cable from battery.
Hoist vehicle.
Disconnect rear wheel speed sensor connector (2) and detach wire harness (1) from vehicle body and rear axle.

Fig 1: Disconnecting Rear Wheel Speed Sensor Connector
Courtesy of SUZUKI OF AMERICA CORP.
Remove harness clamps (2) and sensor bolt (1) and remove rear wheel speed sensor from rear axle.
CAUTION:
- Do not pull wire harness when removing rear wheel speed sensor.
- Do not cause damage to surface of rear wheel speed sensor and do not allow dust, etc. to enter its installation hole.
Fig 2: Removing Clamps
Courtesy of SUZUKI OF AMERICA CORP.