Brake Booster Removal and Installation: Installation
WARNING: This page is about a different car, the 2004 Suzuki Vitara. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- See "BRAKES NOTE ".
- Check length of push rod clevis (2). Refer to "BOOSTER PUSH ROD CLEVIS ADJUSTMENT: ".
- Before installing master cylinder, adjust booster piston rod. Refer to "CLEARANCE BETWEEN BOOSTER PISTON ROD AND MASTER CYLINDER PISTON ADJUSTMENT: ".
- Apply silicone grease to master cylinder piston.
- Install booster to dash panel as shown in the figure. Then connect booster push rod clevis (2) to pedal arm (3) with clevis pin (4) and clip (5).
- Tighten booster attaching nuts (6) to the specified torque.
Tightening torque
Booster attaching nut (a): 13 N-m (1.3 kg-m, 9.5 lb-ft)
- Connect brake vacuum hose to brake booster.
- Install master cylinder referring to "MASTER CYLINDER ASSEMBLY REMOVAL AND INSTALLATION: ".
- After installing, check each part referring to "MASTER CYLINDER CHECK: ".