Oil Pump Removal & Installation: Installation

WARNING: This page is about a different car, the 2003 Suzuki Vitara. However, it is still accessible from the selected car via links, so may be relevant.

Install oil pump (2) to lower crankcase (1) and tighten bolts to specified torque.
NOTE: When installing oil pump, be careful not to allow pins to fall off.

Tightening torque
1. Oil pump mounting bolt (a): 27 N.m (2.7 kg-m, 19.5 lb-ft)
Fig 1: Identifying Oil Pump, Oil Pump Mounting Bolts & Lower Crankcase
Courtesy of SUZUKI OF AMERICA CORP.
Install oil pump sprocket cover (1) and tighten bolts to specified torque.
Tightening torque
1. Oil pump sprocket cover bolt (a): 11 N.m (1.1 kg-m, 8.0 lb-ft)
Fig 2: Identifying Oil Pump Sprocket Cover & Bolts
Courtesy of SUZUKI OF AMERICA CORP.
Install oil pan and oil pump strainer. See OIL PAN, OIL PUMP STRAINER REMOVAL & INSTALLATION .
Refill engine with engine oil. See ENGINE OIL & FILTER CHANGE .
Connect negative cable at battery.
After completing installation, check oil pressure by running engine. See OIL PRESSURE CHECK .