LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2002 >> XL-7 Plus >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Self-Diagnostics >> Diagnostic Tests >> DTC P0327 Or DTC P0328 >> Diagnosis & Repair Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnosis & Repair Procedure

  1. If engine system check has been performed, go to next step. If engine system check has not been performed, go to A4: ENGINE SYSTEM CHECK  under SYSTEM TESTS.
  2. Access ECM. ECM is located under instrument panel, behind glove box. See Figure. Start engine. Backprobing at ECM, measure voltage between ground and ECM connector C51-3 terminal No. 3 (Red/Blue wire). See Figure. If voltage reading is not .90-3.98 volts, go to next step. If voltage reading is .90-3.98 volts, check for poor terminal contact in KS sensor harness connector and at ECM harness connector. If no problem is found, condition is probably intermittent. See INTERMITTENTS in TROUBLE SHOOTING - NO CODES article.
  3. Turn ignition off. Disconnect KS 2-pin harness connector. Turn ignition on. Measure voltage between ground and KS harness connector Red/Blue wire terminal. If voltage reading is 4-5 volts, replace KS. After repair, repeat DTC CONFIRMATION TEST . If voltage reading is not 4-5 volts, go to next step.
  4. Check for open or short to ground in Red/Blue wire between KS and ECM. See WIRING DIAGRAMS article. If wire is okay, check for poor terminal contact at ECM harness connector C51-3. If poor terminal contact is found, repair as necessary. After repair, repeat DTC CONFIRMATION TEST . If no problem with wiring is found, go to next step.
  5. Substitute a known good ECM, and repeat DTC CONFIRMATION TEST . If DTC does not reset, testing is complete.
scientia non olet · About LEMON Manuals